94-97 Honda Accord Sniper Hood Part Instructions

STEP 1: Adjust hood until proper alignment with matching panels is achieved.
STEP 2: Adjust primary latch until it fits into the bar on the hood. Make sure when the hood is closed you can hear the latch “click” onto the hood.
STEP 3: After you here it click, test it to be sure it’s working properly by grabbing the front edge of the hood and slowly pulling upward with a steady even pressure. If the hood opens it’s not adjusted properly; repeat STEP 2 until hood cannot be pulled open after it’s closed.
STEP 4: Make sure the safety catch hook grabs onto its matching bracket on the hood.
STEP 5: To ensure the safety catch is working properly, close the hood, pull the hood release from inside the car and the hood will partially open. Slowly pull upward on the hood and jiggle it at the same time. If it opens without pulling the safety catch lever then it needs to be readjusted. The safety catch prevents the hood from opening in the event the primary latch fails.
STEP 6: Locate the hood stoppers located on each side of the radiator support. Adjust them until they apply a small amount of pressure to the underside of the hood when it is closed. This will prevent the hood from shaking or rocking.
STEP 7: For installation of squirters, follow Fig. A. Install the provided tubing clips in the pre-drilled holes under the hood to secure the hoses. Our application has 1 squirter. You will need to shorten one hose for this application.

Download

Honda Universal Adapter (Accord & Acura Series) Users Manual

Specially designed adapters are used in conjunction with Universal Anchoring System (UAS) stands and Universal Measuring System (UMS) pinchweld stands when securing vehicles with horizontal pinchwelds and vertical jack tabs in the corners of their center sections. (All Honda / Accord / Acura vehicles excluding Odessey.) These adapters allow the positioning of vertical jack tabs into a slot on the adapter’s top surface, and the attachment of 4 inch clamps to horizontal pinch-welds.

The Honda adapters attach to UAS stands in two ways dependent upon anchoring tube used. Figure 1 shows attachment to the ears of a UAS clamp bar tube. Figure 2 shows attachment to the vertical surface of a UMS adapter tube. Figure 3 shows attachment to the vertical surface of a UMS pinchweld stand. Each illustration shows the Honda adapter in its lowest mounted position.

Download