VW Golf A5 Variant RHD, 13-pin Electrical Installation Kit

Before starting work read the installation instructions.
The electrical installation kit may only be fitted by qualified specialists.
Follow guidance in the current repair manual when carrying out installation work on the vehicle.
The ABS control unit must be recoded for activation of the trailer stabilisation system.
Caution - disconnect battery
Damage to the vehicle electronics may result in loss of stored electronic data.
Before starting work read out error memory.

Note
When fitting, pay particular attention to the following points:
• Wiring must not be pinched or damaged.
• All seals must be properly seated.
• The seal for the socket must be positioned on the insulating sleeve and not on the individual wires.
• Route wiring so that it does not chaff against the vehicle or break off.
• Do not route wiring immediately next to the exhaust system.
Failure of a trailer light (also the indicators, not reversing light and rear fog light) is shown by the lamp failure indicator on the instrument panel. There is no additional warning lamp (C2) in the vehicle for checking the turn signal indicators on the trailer.
For trailer operation the rear fog light of the towing vehicle is disabled.
A rear fog light must be retrofitted on trailers not already equipped with one.
A socket adapter may only be used in trailer operation. Remove the socket adapter when trailer operation is not in use.
Check the operation of the trailer using a trailer or test equipment with load resistances.
Technical changes reserved!

Download

2007 Nissan Pathfinder Reference Manual Guide

Twist the end section to operate the first INT or second ON speed settings for the rear wipers The washer function activates the washer fluid and several sweeps of the wipers For FRONT WASHER pull lever toward you For REAR WASHER push lever away from you headlight and turn signal control HEADLIGHT SWITCH Turn the headlight switch to the position to turn on the front parking tail license plate and instrument panel lights.

Turn the headlight switch to the position to turn on the headlights All other lights remain on HIGH BEAM Push the headlight switch forward to select the high beam function The blue indicator light illuminates Pull the headlight switch back to the original position to select the low beam The blue indicator light goes off Pull and release the headlight switch to flash the headlight high beams on and off TURN SIGNAL SWITCH Move the headlight control switch up or down to signal the turning direction When the turn is completed the turn signals cancel automatically To signal a lane change move the headlight control switch up or down to the point where the indicator light begins to flash but the headlight control switch does not latch AUTOMATIC HEADLIGHT OPERATION if so equipped The autolight system can Turn the headlights on automatically when it is dark Turn the headlights off automatically when it is light Keep the headlights on for 45 seconds after you turn the ignition switch to OFF and all doors are closed TO ACTIVATE THE AUTOLIGHT SYSTEM Turn the headlight switch to the AUTO position then turn the ignition switch to ON TO DEACTIVATE THE AUTOLIGHT SYSTEM Turn the headlight switch to the OFF FOG LIGHT OPERATION.

Download