2003 Honda CR-V Fog Light Installation Instructions

The information in this installation instruction is intended for use only by skilled technicians who have the proper tools, equipment, and training to correctly and safely add equipment to your vehicle. These procedures should not be attempted by “do-it-yourselfers.”
NOTE: These installation instruction show the left fog light begin installed. The same procedure applies to installing the right fog light.

1. Make sure you have the anti-theft code for the radio, write down the frequencies for the preset buttons.
2. Disconnect the negative cable from the battery. Installing the Fog Light
3. Open the hood. Loosen the battery bracket nut. Remove the radiator cover (seven clips and one bolt).
4. Remove the four clips, four bolts, and two self-tapping screws that fasten the front bumper. Remove the front bumper.
5. Using masking tape, cover the bumper around the fog light opening.
6. Using a utility knife, slowly and carefully cut out the fog light opening. Be sure to cut your lines as straight as possible, and do not damage the bumper. Remove any burrs from the edges of the fog light grille opening with a file.
7. Attach the rubber trim to the edge of the fog light opening.
8. Position the left fog light adjuster on the left fog light, and install one step screw and one 4 x 8 mm washer-screw.

Download

2008+ Mitsubishi Lancer QuickLIFT Installation Guide

Remove all items from the packing tube. You should have the following before beginning:
* (2) Gas springs (RT-QL-170-A6A) - Be sure to cycle them a few times before installing.
* (4) #2-3/16" Multi-grip rivets (used on hood brackets)
* (2) ball-studs and washers each with a locking nut.
* (2) mounting brackets
* Printed Color Instructions
* Gas Spring locking clips - (Already installed in the gas spring ball-ends - Remove before assembly)

Please gather the following tools before you begin the installation:
* Power Drill
* 3/16", indexed #11 & 5/16" drill bits
* Fine permanent marker or felt tip pen
* Tape measure or ruler
* Masking tape
* Hammer & center punch
* Rivet gun,capable of 3/16" rivets (most brands can handle this size)
Note: Only use the rivets supplied in the QuickLIFT system.

A. Open and prop your hood.
B. Standing on the driver’s side in the middle of the engine compartment,examine the area on the inner fender lip.
Note the overhanging fender mounting bolt. The centerline of this bolt should be used to align the ball-stud mounting bracket (offset 3/8”to the left or front of the vehicle). Back of bracket up against lip.
C. Place the bracket on the flat surface aligning either the left edge of the bracket with the metal shown below,or using the measurement shown to the right (centerlines offset by 3/8”).

Download