Installation Procedure:
1. Unscrew the stock shift knob by rotating it counter clockwise.
2. Use a Philips head screwdriver to remove the 2 screws on either side of the console just behind the shift boot. Sliding the seats fully rearward allows easy access to these screws.
3. Slide the front seats fully forward and use a Philips head screwdriver to remove the 2 screws on either side of the back of the center console.
4. Lift the rear portion of the center console out of the car and put in a safe place for re-installation.
5. Locate the clips at the top front portion of the center console. Gently push in the center portion of these clips with your finger or a screwdriver, and then pull out on them to remove them.
6. Pull the plate surrounding the stereo out slightly to free the front portion of the console.
7. Use needle nose pliers to disconnect the clip holding the cigarette lighter power connector to the steel bracket.
8. Disconnect the power connector from the cigarette lighter on the front portion of the console.
9. The front portion of the center console can now be removed from the car. Lift it up from the rear and pull up and out of the car.
10. Use a flat head screwdriver and a hammer to pry the clip on the passenger side of the assembly off of the shaft. Use caution during this step as the clip may break and become a dangerous projectile. Use the screwdriver and wedge it between the plastic assembly and the clip and gradually work it off the shaft. Alternatively, a Dremel tool may be used to cut the clip off as a new one is included in the kit.
11. Remove the clip from the side “L” shaped arm and slide the shift cable off the side arm.
Download
No comments:
Post a Comment