94-97 Honda Accord Sniper Hood Part Instructions

STEP 1: Adjust hood until proper alignment with matching panels is achieved.
STEP 2: Adjust primary latch until it fits into the bar on the hood. Make sure when the hood is closed you can hear the latch “click” onto the hood.
STEP 3: After you here it click, test it to be sure it’s working properly by grabbing the front edge of the hood and slowly pulling upward with a steady even pressure. If the hood opens it’s not adjusted properly; repeat STEP 2 until hood cannot be pulled open after it’s closed.
STEP 4: Make sure the safety catch hook grabs onto its matching bracket on the hood.
STEP 5: To ensure the safety catch is working properly, close the hood, pull the hood release from inside the car and the hood will partially open. Slowly pull upward on the hood and jiggle it at the same time. If it opens without pulling the safety catch lever then it needs to be readjusted. The safety catch prevents the hood from opening in the event the primary latch fails.
STEP 6: Locate the hood stoppers located on each side of the radiator support. Adjust them until they apply a small amount of pressure to the underside of the hood when it is closed. This will prevent the hood from shaking or rocking.
STEP 7: For installation of squirters, follow Fig. A. Install the provided tubing clips in the pre-drilled holes under the hood to secure the hoses. Our application has 1 squirter. You will need to shorten one hose for this application.

Download

Spin-On By-Pass Filter Installation and Servicing Instructions

Attaching the filter mount
1. Survey the engine compartment for possible mounting locations. Solid structures such as the firewall, fender well, radiator support or frame are normal locations. (Do not mount on engine.) Refer to diagram B for minimum area requirements and consider accessibility for servicing.
2. Refer to diagram A for preferred mounting positions.
3. When the location has been determined, use the mounting template provided to locate and mark mounting holes. This can be easily done with a center punch and hammer.
4. Install adapter fittings (BP-208) on filter mount using provided thread sealant as noted in diagram C. If desired, 90° angle fitting (BP-52) may also be used. Using a 7⁄16 wrench, tighten fittings 2-3 turns beyond finger tight. Keep in mind the direction you wish to have the hoses intersect the mount.
5. With a 5⁄16 drill bit, drill out the previously marked mounting holes and attach the mount using the 5⁄16 bolts, nuts, small washer and fender washers provided. Bolts should be tightened to 16-18 foot pounds. 1/2 wrenches or socket will be required for this operation.
6. Fill the By-Pass Filter element with the same motor oil being used in the vehicle. Lubricate the filter gasket with oil and spin filter onto mount. Tighten per instruc- tions on the filter.

Download