Getting Started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake. Install rear wheel chocks.
c) If the engine has run with in the past two hours let it cool down.
d) Jack the front of the vehicle and support using properly rated jack stands.
e) Remove the left front wheel.
Removal of the Stock Air Intake System
a) Loosen the clamp around the throttle body using
a 5.5mm socket or screwdriver. Pull the Intake Air Temperature (IAT) sensor out of the intake tube by loosening the spring loaded clamp.
b) Unplug the breather tube from the fitting underneath the intake manifold
c) Remove the air box mounting bolt shown in the picture.
d) Remove the other air box mounting shown in the picture.
e) Carefully remove the air box assembly from the engine bay.
f) Remove the two fasteners holding the plastic cover in front of the battery.
g) Pull upward on the plastic cover to remove the resonator box intake tube.
h) From inside the driver-side wheel well, remove the fastener shown in the picture.
i) From underneath the vehicle, remove the fasteners shown in the picture.
j) Tuck the splash guard out of the way behind the brake rotor.
k) Remove the resonator mounting bolt shown in the picture.
l) Remove the screw holding the corner of the front bumper cover.
Download
No comments:
Post a Comment