2006-2007 Honda Civic DX/LX/EX 1.8L Cold Air System Instructions

Read and understand these instructions BEFORE attempting to install this product.
1) Getting started
a) Make sure vehicle is parked on a level surface.
b) Set parking brake.
c) Make sure you have the anti-theft code for the radio.
d) Disconnect negative battery terminal.
e) If engine has run within the past two hours let it cool down.

2) Removing the stock air inlet system
a) Pry loose the retaining buttons on the lower splash shield.
b) Remove all retaining buttons on the fender liner around the fender well.
c) Carefully pull back the fender liner and splash shield to gain access to the fender well and stock resonator box.
d) Remove the battery from the engine bay.
e) Remove the plastic battery tray.
f) Remove the two bolts that secure the intake arm to the battery tray.
g) Slide the rubber part of the intake arm off of the airbox inlet. Remove the intake arm from the engine bay.
h) Disconnect the MAF sensor harness. Remove the harness clip from the airbox and move the harness out of the way.
i) Push back all the clips holding the filter lid, and remove the lid and the air filter from the vehicle.
j) Separate the lines from the rubber coupler. Loosen the hose clamp at the throttle body end of the rubber coupler.
k) Pull the metal breather line out of the rubber grommet on the airbox.
l) Pull the metal breather line out of the rubber hose attached to the valve cover. Then pull the rubber hose off the valve cover.

Download