For vehicles without Navigation system To deactivate Press and hold the and buttons for at least 2 seconds To activate Press and hold the and LPD0150 lpd0151 least 2 seconds buttons for at LPD0150 lpd0151 For vehicles with Navigation system Refer to the Display screen heater air conditioner and audio systems section in your Owners Manual for the procedure.
If you change the horn beep feature with the keyfob the display screen will not show the current mode and cannot be used to change the mode Use the keyfob to return to the previous mode and re enable the display screen control intelligent key systeM if so equipped The Intelligent Key System allows you to lock or unlock your vehicle and start the engine NOTE It is important to make sure the Intelligent Key is with you that is in your pocket or purse The operating range of the door and trunk lock unlock function is approximately 31 in 0 8 m Locking the vehicle Push any door handle Request Switch 01 once Unlocking the vehicle Push any door handle Request Switch 01 once The corresponding door will unlock Push the door handle Request Switch 01 again within 1 minute all other doors including liftgate and liftgate glass will unlock 01 It is also possible to change the default settings of the Intelligent Key unlock lock by using the Comfort Convenience mode under Settings in the control panel StaRtiNg the eNgiNe Push the ignition knob in Confirm the Intelligent Key warning light is illuminated green Turn the ignition knob to start the engine 2 tURNiNg the eNgiNe OFF Shift the transmission into P Park Turn the ignition knob to the LOCK position An audible warning chime will sound when exiting the vehicle if the ignition knob is not completely turned to the OFF position Windshield Wiper Washer sWitch The ignition switch must be in the ON position to activate the windshield wipers Move the lever to the following positions to operate the windshield wipers 1a 04 1b 05 Intermittent iNt Front wipers operate intermittently and can be further adjusted by twisting the time control ring 1b Low Speed LO Continuous low speed operation of front wipers High Speed hi Continuous high speed operation of front wipers Mist miSt Lift the lever up for one sweep of the front wipers Rear Wipers ReaR Twist the end section to operate the first iNt or second ON speed settings for the rear wipers 02 03 04 05 1a 02 03 The washer function activates the washer fluid and several sweeps of the wipers.
Download
No comments:
Post a Comment