Attaching the Power Head (Engine) to the Power Frame: Be sure to pay special attention to torque settings. Standard Torque Values 0.118 in. (3 mm) Thread-Diameter Philips Screw 0.7 lb•ft (1 N•m) 0.197 in. (5 mm) Thread-Diameter Philips Screw 3.6 lb•ft (5 N•m)
1. Read the owner’s manual before starting or using your Screed unit.
2. Set the Power Frame Unit on a level surface
3. Remove screw A with a phillips screwdriver.
4. Guide the Engine onto the Driveshaft Housing aluminum tube.
5. Orient the mounting hole from screw A with the hole on the driveshaft housing. If you cannot get the holes to align, it is because the driveshaft is not fully seated. Most likely, the splines are not aligned with the engine. Try the following: wiggle or twist the engine, while pressing onto the driveshaft housing. turn the eccentric weights by hand, while pressing the engine onto the shaft. You will feel the engine “drop” into position once the splines are lined up. If the holes are not aligned, the engine is not properly seated on the driveshaft, and the driveshaft splines will grind off as soon as the engine is started.
6. Once the engine is seated, re-install screw A on the Engine Mounting Bracket.
7. Securely tighten screw B to 3.6 lb•ft (5 N•m).
Download
No comments:
Post a Comment